|
|
|
Floating Trunk
This car modification tunes your trunk and makes it appear like it is floating.
Floating flip trunk modification instructions:
1) This part must be cut out. You must measure
1/2
of the thickness of the bar, and cut exactly that
much
above the hole you are about to drill to make
it sit
flat (not leaning back).
2) Remove this screw. Drill a new hole here, right
through the stock hole. This will be the pin that
trunk
rotates on. The stock hole is slotted. Make
sure the pin
fits loosely, which will allow it more
play so it will
sit sideways.
3) Drill a NEW hole here (not through the other
stock hole). This will be the pin you remove.
You can
replace this pin, to lock it back into
stock operation.
Make sure this hole is drilled
near exact diameter of
your pin or your trunk
will sit up too high.
4) Remove the stock screw. You will have to
grind
the inside a bit, to allow it to clear the
bar, unless
you cut you hole to big. Don't
grind too much, so you
can still replace the
stock screw if you want to get rid
of the flip flop.
NOTE: If you have a wing, tighten the springs
to
make it stay up. I had to shorten mine.
.
The trunk will now sit sideways OR sit like a
normal
flip flop.
Pics of the finished product:
|
|
|
|
|
|
|
|
|
|
